Design and Analysis of Draw Die for Fuel Filler Cap |
Author(s): |
| Revan Puri , SKN SINHGAD INSTITUTE OF TECHNOLOGY AND SCIENCE; Durvesh Dandekar, SKN SINHGAD INSTITUTE OF TECHNOLOGY AND SCIENCE; Milind Gawai, SKN SINHGAD INSTITUTE OF TECHNOLOGY AND SCIENCE; Ajay Gaikwad, SKN SINHGAD INSTITUTE OF TECHNOLOGY AND SCIENCE; Harshwardhan Galave, SKN SINHGAD INSTITUTE OF TECHNOLOGY AND SCIENCE |
Keywords: |
| Draw Die, Blank-Holder Design, Finite Element Analysis |
Abstract |
|
This paper reports on the initial stages of a combined experimental and finite element analysis (FEA) of a deep drawing process. A deep drawing rig was designed and built for this purpose. Punches and dies of various geometries were manufactured. It has also been observed from the work to date that the speed of drawing plays an interesting role in so far as, the higher is the speed the further is the draw, which is not entirely as expected. The cause of this will be further investigated. If the blank-holder force is not kept within the upper and lower limit of reasonable range it does have a significant effect on depth of draw, with the punch tearing through the bottom of the cup if the force is too high and if too low wrinkling of the flange area occurs. |
Other Details |
|
Paper ID: IJSRDV6I40527 Published in: Volume : 6, Issue : 4 Publication Date: 01/07/2018 Page(s): 497-498 |
Article Preview |
|
|
|
|
